⟁ Minnesota Well Data field records · 2026 survey

Minnesota Well Data › Mcleod County › Stewart (55385)

Stewart, MN (55385): well depth, water level & drilling cost

✓ 214 CWI records · Mcleod County

159 ftmedian well depth
110 ft–256 fttypical depth range
26 ftmedian static water level
45 gpmmedian yield (207 tests)

How deep are wells in Stewart (55385), Minnesota?

The median drilled well depth in Stewart (55385) is 159 ft, based on 214 wells with recorded depths in the state CWI database. Half fall between 110 ft and 256 ft; 90% are shallower than 331 ft.

How much does it cost to drill a well in Stewart (55385)?

Applying published per-foot rates to the local median depth of 149 ft: drilling and casing alone typically runs $3,725–$9,685; a complete system including pump, pressure tank, and hookup typically runs $8,940–$14,900. Actual quotes depend on site access, geology, and casing requirements.

What is the static water level in Stewart (55385)?

The median static water level is 26 ft below ground surface (middle half of wells: 20 ft–34 ft), from 195 measurements.

Pull every recorded well near a Stewart (55385) address — $19

Drilled depth distribution

0–50 ft 0 50–100 ft 41 100–150 ft 59 150–200 ft 16 200–300 ft 60 300–400 ft 38 400–600 ft 0 600+ ft 0
Looking at a specific property in Stewart (55385)?

See every recorded well near any address — depths, water levels, yields, original driller's logs — in a one-time report.

Free lookup Property report — $19

Part of Mcleod County well records.

Method: medians computed from CWI records (water-supply wells only (domestic, irrigation, public/community supply, commercial, industrial) — monitoring, observation, test, injection, heat-pump and environmental boreholes excluded; depths 0–5,000 ft), grouped by ZIP from the recorded address. Cost estimate applies published per-foot ranges to the local median depth — full methodology & sources.